RUPES LHR15 Mark V, HLR15 iBRID Rubber Shroud

RUPES LHR15 Mark V, HLR15 iBRID Rubber Shroud is an original spare part designed for RUPES BigFoot polishing machines.

This part is installed in the front section of the polisher, near the backing pad / eccentric area. Its purpose is to help protect the internal machine components from dust, polishing compound residue, dirt and other particles created during polishing work.

The rubber shroud is a wear part that can become worn, lose elasticity, tear or deform over time. In this case, it is recommended to replace it with a new part so that the machine remains clean, safer to use and properly protected during work.

This shroud is suitable for professional use in detailing centres, car workshops, body repair shops and any place where RUPES polishing machines are used intensively.

Suitable for these models:

RUPES LHR15 Mark V

RUPES LHR15V

RUPES HLR15 iBRID

Product code:

651.397/C

Main features:

Original RUPES spare part

Rubber shroud / backing pad area protection

Designed for RUPES LHR15 Mark V

Designed for RUPES HLR15 iBRID

Suitable for LHR15V models from 2024

Helps protect internal components from dust

Helps reduce polishing compound residue entering the machine

Suitable for replacing a worn rubber shroud

Suitable for replacing a damaged or torn rubber shroud

Made according to RUPES machine design

Suitable for professional repair and maintenance

Used for polishing machine servicing

Suitable for detailing centres and workshops

Product code: 651.397/C

Use:

Before replacing the shroud, disconnect the polishing machine from power or remove the battery if using the HLR15 iBRID model. Remove the worn or damaged rubber shroud according to the machine construction and install the new part.

If you are not sure about installation, it is recommended to follow the RUPES spare parts diagram or contact a qualified tool repair specialist.

Note:

Before ordering, it is recommended to check the polishing machine model and part code according to the spare parts diagram. This part is intended for LHR15 Mark V / LHR15V and HLR15 iBRID models, so it is not the same version as the older LHR15ES / Mark II / Mark III rubber shroud.