FARECLA G3 PASTE Cutting and Polishing Compound 250 g
| ID: | G3-250 |
FARECLA G3 PASTE is a medium-to-high-cut compound designed to remove P1500 or finer sanding marks. It contains no silicone or fillers that temporarily conceal defects, ensuring fast and permanent results. Suitable for hand or machine application.
FARECLA G3 PASTE, officially named G3 Regular Grade Paste Compound, is a professional medium-to-high-cut compound for correcting painted and lacquered automotive surfaces.
The compound reliably removes P1500 or finer sanding marks and other surface defects. It is suitable for both OEM and refinishing paint systems. The formula contains no fillers that temporarily conceal imperfections, ensuring genuine and permanent surface correction.
FARECLA G3 PASTE can be applied by hand or with a rotary polishing machine. The compound must be used with water. Regularly misting the surface or polishing pad with water helps maintain the correct working consistency and prevents the compound from drying too quickly.
A foam compounding pad provides a good balance between cutting performance and gloss while reducing splatter. A wool pad is recommended when more intensive paint correction is required. For maximum gloss, especially on dark colours, follow with FARECLA G3 Fine Finishing Compound.
Main features:
• Medium-to-high cutting performance.
• Removes P1500 and finer sanding marks.
• Provides fast and permanent results.
• Contains no defect-masking fillers.
• Silicone-free and bodyshop safe.
• Suitable for OEM and refinishing paint systems.
• Can be applied by hand or machine.
• Designed to be used with water.
• Suitable for professional body repair and polishing work.
Machine application:
- Soak the polishing pad in water and remove the excess.
- Mix the compound thoroughly and apply a small amount to the pad or surface.
- Polish a small section at a time at approximately 1500–1800 RPM.
- Mist the surface with additional water when required.
- Remove the compound residue using a clean microfibre cloth.
- If a high-gloss finish is required, complete the process with a fine finishing compound.
Hand application:
Dampen a clean microfibre cloth with water and wring it out. Apply a small amount of compound and polish the surface using straight back-and-forth movements. Remove the remaining product with a clean microfibre cloth.
Do not use in direct sunlight or on hot surfaces. Do not allow the compound to dry. Test on an inconspicuous area before use. Follow the instructions provided on the product label and safety data sheet.
Technical information:
Weight: 250 g
Product code: G3-250
Manufacturer code: 78072709133
Cut level: medium–high
Sanding marks removed: P1500 or finer
Application: by hand or polishing machine
Recommended machine speed: 1500–1800 RPM
Silicone: none
Fillers: none
