RUPES Bearing for BigFoot Polishing Machines 56.245N/C
| ID: | 56.245N/C |
| Manufacturer: | RUPES |
Original RUPES spare part – bearing / eccentric shaft assembly for BigFoot polishing machines. Designed to replace a worn, damaged or improperly working assembly when the machine starts making unusual noise, vibrating, losing stability or when the backing pad movement becomes uneven. Suitable for RUPES LHR12 E, LHR15 ES, LHR21 ES, LHR15 Mark II, LHR21 Mark II, LHR15 Mark III and LHR21 Mark III models.
RUPES Bearing for BigFoot Polishing Machines 56.245N/C is an original spare part designed for the repair and maintenance of RUPES BigFoot random orbital polishing machines.
In the manufacturer’s spare parts diagrams, this part is listed as Eccentric Shaft Assembly, so it is not just a simple separate bearing, but an eccentric shaft / bearing assembly related to the backing pad movement mechanism. This part helps ensure smooth, stable and precise movement of the polishing pad.
Eccentric mechanism parts in intensively used polishing machines can wear over time. Wear may cause increased vibration, unusual noise, looseness, uneven backing pad movement or reduced working comfort. In such cases, it is recommended to replace the worn assembly with an original RUPES part.
This part is suitable for professional tool repair, polishing machine servicing and preventive maintenance. It is especially useful for detailing centres, car workshops, body repair shops, paint preparation areas and anyone who uses RUPES BigFoot polishing machines intensively.
Suitable for these models:
RUPES LHR12 E
RUPES LHR15 ES
RUPES LHR21 ES
RUPES LHR15 Mark II
RUPES LHR21 Mark II
RUPES LHR15 Mark III
RUPES LHR21 Mark III
Product code:
56.245N/C
Other possible code markings:
RU-56.245N/C
56.245N C
56245NC
Main features:
Original RUPES spare part
Bearing / eccentric shaft assembly
Official name in diagrams: Eccentric Shaft Assembly
Designed for RUPES BigFoot polishing machines
Suitable for LHR12 E model
Suitable for LHR15 ES and LHR21 ES models
Suitable for LHR15 Mark II and LHR21 Mark II models
Suitable for LHR15 Mark III and LHR21 Mark III models
Helps restore smooth backing pad movement
Helps reduce unusual noise caused by wear
Helps reduce looseness and uneven movement
Suitable for replacing a worn assembly
Suitable for professional repair
Suitable for polishing machine servicing
Used in the eccentric mechanism area
Suitable for detailing centres, workshops and tool repair specialists
Use:
Before repair, disconnect the polishing machine from the power supply. Disassemble the machine according to the RUPES spare parts diagram, remove the worn or damaged assembly and install the new part.
When replacing this part, it is recommended to check other related eccentric mechanism parts, bearings, washers, retaining rings, backing pad mounting and rubber shroud. If you are not sure about the repair, it is recommended to contact a qualified tool repair specialist.
Note:
Before ordering, always check the polishing machine model and part code according to the spare parts diagram of the specific model. The part must only be replaced in the correct model and installed according to the manufacturer’s construction.
